Buick vehicles are thought-about luxurious cars that ship automotive efficiency and comfort to their owners. The stereo system in a Buick Regal consists of essentially the most powerful deck out there as an ordinary characteristic for any GM vehicle in addition to premium speakers. Even so, some Buick house owners might want the extra energy and capability that they covet via an aftermarket stereo. You can install a brand new radio your self for a fraction of the price of knowledgeable doing it for you.
Buick Stereo/Radio Installation Instructions
1. Lift the hood of your Buick Park Avenue to entry the vehicle’s battery.
2. Loosen the bolt on the unfavorable battery cable with a 10 mm wrench and take away the cable from the negative battery terminal.
3. Pry the trim panel beneath the stereo away from the dashboard with a trim panel elimination tool. Pry the trim panel to the left of the steering column, away from the dash.
4. Pry the sprint panel on the facet of the dashboard (driver’s aspect door) away from the primary paneling. Remove the bolt screw behind the panel with a 7 mm socket and drive.
5. Pull the primary dash panel away from the dashboard manually.
6. Remove the three bolt screws holding the factory stereo to the stereo mounting bracket with the socket and drive.
7. Slide the factory stereo from the dashboard and disconnect the stereo wiring linked to the rear panel of the radio. Unplug the black antenna cable from the precise facet of the radio‘s rear panel.
8. Slide the mounting collar from the GM aftermarket stereo set up kit into the empty stereo dock. Push the collar clips outward with a flat head screwdriver.
9. Pull the Park Avenue’s stereo wiring by means of the entrance of the stereo dock. Connect the plastic wire clips on the wiring to the leads of the wiring harness adapter.
10. Place the GM antenna adapter over the antenna lead. Plug the adapted antenna cable into the corresponding outlet on the rear panel of the new stereo.
11. Plug the wiring harness leads into the appropriate shops on the left facet of the aftermarket stereo’s rear panel.
12. Slide the brand new stereo into the mounting collar till it snaps into place. Substitute the three bolt screws on the aspect of the stereo dock.
13. Align the primary dash panel and press it against the dashboard of the Buick.
14. Replace the bolt screw on the motive force’s side edge of the sprint panel with the socket and drive.
15. Place the trim panels in opposition to the dashboard and press firmly across their length to snap them back into place on the dash.
16. Place the destructive battery cable onto the Buick battery’s negative lead post. Tighten the cable to the put up with the wrench and shut the hood.
